II.1)
[QuantityScopeContract]
AIT - Provision of a Scanning Thermal Microscope with Nano Thermal analysis capabilities
[Fileref]:
LEE935C
[Supplies]
Tenders are sought for the supply, delivery & installation of a Scanning Thermal Microscope with Nano Thermal analysis capabilities. The system must be based on an atomic force microscope (AFM) where the AFM must be supplied with a module or modules that combine the high spatial resolution imaging capabilities of atomic force microscopy with the ability to obtain an understanding of the thermal behaviour of materials with a spatial resolution of sub-100 nm.
II.1.5)
[ValueMagnitudeEstimatedTotal]
[ValueExclVat]: 235000.00
EUR
[DivisionLots]:
[No]
38510000
-
38511000
-
38511100
-
38511200
-
38512000
-
38512100
-
38514200
-
38515000
-
38515100
-
38515200
-
38634000
-
II.2.4)
[DescrProcurement]
Tenders are sought for the supply, delivery & installation of a Scanning Thermal Microscope with Nano Thermal analysis capabilities. The system must be based on an atomic force microscope (AFM) where the AFM must be supplied with a module or modules that combine the high spatial resolution imaging capabilities of atomic force microscopy with the ability to obtain an understanding of the thermal behaviour of materials with a spatial resolution of sub-100 nm.
One capability must specifically provide nanoscale temperature and thermal conductivity measurements whilst simultaneously obtaining topography.
The set-up must have the ability to visualise the surface at nanoscale resolution with the AFM’s routine imaging modes and enable the user to select the spatial locations at which they will investigate the thermal properties of the surface by applying heat locally via the probe tip and measuring the thermomechanical response. The system must have calibration capabilities in order to provide results in degrees Celsius. This calibration procedure should also take into account any parasitic thermally-induced cantilever bending. An Enclosure and Vibration Isolation table must also be provided with this unit.
[AwardCriteriaDescriptive]
II.2.6)
[ValueMagnitudeEstimated]
[ValueExclVat]: 235000.00
EUR
II.2.7)
[DurationContractFrameworkDps]
[DurationMonths]:
12
[RenewalsSubject]:
[Yes]
[RenewalsDescr]:
The Contracting Authority reserves the right to extend the Term of warranty and/or service contracts for a period or periods of up to [1 Year] with a maximum of (4) such extension or extensions on the same terms and conditions, subject to the Contracting Authority’s obligations at law.
[VariantsAccepted]:
[No]
[Options]:
[No]
[EuProgrRelated]:
[No]