II.1)
[QuantityScopeContract]
Framework Agreement for the Supply of IP HD Cameras and PTZ CCTV Cameras
[Fileref]:
7192
[Supplies]
This is a call to competition by IE for the establishment of a Framework Agreement for The Supply of IP HD Cameras and PTZ CCTV Cameras.
This is Single Supplier Framework Agreement with two Lots:
Lot One: Supply of IP HD Cameras
Lot Two: Supply of PTZ CCTV Cameras
The requirement for both Lots includes the supply of Cameras associated hardware and software to various locations including but not limited Limerick, Dublin, Cork and Westport. The requirement is supply and delivery of equipment only; design, installation and maintenance are not required under either Lot of this Framework Agreement.
As this is a single Supplier Framework, one Supplier will be the sole supplier for each Lot. Bidders are able to bid for both Lots.
Spend and quantities of equipment under both Lot are not guaranteed under this Framework.
[DivisionLots]:
[Yes]
Supply of IP HD Cameras
[LotNumber]:
1
II.2.4)
[DescrProcurement]
Lot One: Supply of IP HD Cameras
This equipment is required to upgrade current composite CCTV sites and integrate with current IP CCTV sites. A full technical specification will be provided at tender stage. The requirements include, but are not limited to:
• Bullet cameras
• HD Dome cameras
• HD Micro cameras
• Wide angle / panoramic cameras
• Licence plate cameras
• Relevant accessories for all comers and equipment
II.2.5)
[AwardCriteria]
( [HAgreeToPublish] [Yes] )
[AwardCriteriaBelow]
[AwardCriterionQuality]
-
[AwardCriterionName]:
Technical Specification
/
[Weighting]:
30%
[Price]
-
[Weighting]:
70%
[Options]:
[No]
[EuProgrRelated]:
[No]
Supply of PTZ CCTV Cameras
[LotNumber]:
2
II.2.4)
[DescrProcurement]
Lot Two: Supply of PTZ CCTV Cameras
This equipment is required to replace existing stationary cameras currently in use at Level Crossings, will be controlled from an equipment room located at Level Crossings and viewed remotely by a signalman. A full technical specification will be provided at tender stage. The requirements include, but are not limited to:
• Analogue image with low voltage power supply.
• Lens with a minimum of 64 degree wide angle
• Pole top and wall mounts
• Pelco P 9600 control protocol
• A wiper which can be triggered remotely by a dry contact separate from the keyboard.
• Following restart after power loss/reset, the camera must automatically move to a preset location.
• Capability to operate at a distance of 80m from its power supply and connection junction box.
• The height of the on-screen text must take up approximately 6 percent of the screen.
• It must be possible to position the text at any position on the screen
[Options]:
[No]
[EuProgrRelated]:
[No]